This is part of the MakeBus project.

MakerBus 3.0 Modules

The following MakerBus 3 modules exist:

MBino
An Arduino® compatible board that attaches to a MakerBus and allows the integrations of hundreds of Arduino compatible shields into a MakerBus system.
MBPi
A host adapter board that connects a Raspberry Pi® host to a MakerBus.
Motor3
A 3 Ampere H-bridge with 5-pin quadrature encoder connector.
Splice2
A board to splice two Robus cables together. It can also be used to terminate a bus.
Power
A power connection board with optional bus termination.
Motor30
A 30 Ampere H-bridge with an on-board hall effect shaft angle sensor.
Panda1
An LPC1754 ARM coprocessor board for the TI PandaBoard OMAP4 ARM processor board.
ICSP
An In-Circuit Serial Programming board
RB2
A board to switch from Robus electrical connections to RB2 electrical connections. A voltage regulator is provided to provide the regulated 5V needed for RB2 bus.


Copyright 2011-2013 by Wayne C. Gramlich All rights reserved.