This is revision A of the Terminate Module.

Terminate Module (Revision A)

Table of Contents

This document is also available in PDF format.

• 1. Introduction
• 2. Hardware
  • 2.1 Circuit Schematic
  • 2.2 Printed Circuit Board
• 3. Issues

1. Introduction

The Terminate module is used to terminate a RoboBricks2 bus cable.

2. Hardware

The hardware consists of a circuit schematic and a printed circuit board.

2.1 Circuit Schematic

The schematic for the Terminate Module is shown below:

The parts list kept in a separate file -- terminate.ptl.

2.2 Printed Circuit Board

The printed circuit board files are listed below:

terminate_back.png

The solder side layer.

terminate_front.png

The component side layer.

terminate_artwork.png

The artwork layer.

terminate.gbl

The RS-274X "Gerber" back (solder side) layer.

terminate.gtl

The RS-274X "Gerber" top (component side) layer.

terminate.gal

The RS-274X "Gerber" artwork layer.

terminate.drl

The "Excellon" NC drill file.

terminate.tol

The tool rack file.

3. Issues

Any issues that come up are listed here.