This is the Revision C verion of the Servo_Adaptor0_4. The status of this project is finished.

Servo_Adpator0_4 (Revision C)

Table of Contents

This document is also available in PDF format.

1. Introduction

The Servo_Adaptor0_4 is used to mount servos whose mounting holes are 1.9" by 0.4 inches.

2. Hardware

The hardware consists of a circuit schematic and a printed circuit board.

2.1 Circuit Schematic

The schematic for the Servo_Adaptor0_4 RoboBrick is shown below:

Servo Adaptor 0.4 Schematic

The parts list kept in a separate file -- servo_adaptor0_4.ptl.

2.2 Printed Circuit Board

The printed circuit board files are listed below:

servo_adaptor0_4_back.png
The solder side layer.
servo_adaptor0_4_front.png
The component side layer.
servo_adaptor0_4_artwork.png
The artwork layer.
servo_adaptor0_4.gbl
The RS-272X "Gerber" back (solder side) layer.
servo_adaptor0_4.gtl
The RS-272X "Gerber" top (component side) layer.
servo_adaptor0_4.gal
The RS-272X "Gerber" artwork layer.
servo_adaptor0_4.drl
The "Excellon" NC drill file.
servo_adaptor0_4.tol
The "Excellon" tool rack file.

3. Issues

Any fabrication issues will be listed here.


Copyright (c) 2003-2004 by Wayne C. Gramlich. All rights reserved.